Leg Press
The leg press is a machine squat lying back: with your back supported, you lower a weighted sled towards you by bending your knees, then press it away. It lets you load your legs heavily without balancing a bar.
- TYPE
- Compound: works hips and knees together
- PRIMARY MUSCLES
- Quads
- ALSO WORKING
- Glutes, adductors, hamstrings, calves
- EQUIPMENT
- 45-degree leg press machine
- DIFFICULTY
- Beginner
Form images
Muscles worked
- PRIMARY
- Quads
- ASSISTING
- Glutes, adductors, hamstrings, calves
The leg press is mainly a quad exercise, helped by the glutes and adductors. Where you put your feet shifts the balance between them.
- Quads do most of the work, and they worked harder the more the knees bent [1].
- Glutes and adductors help straighten the hips at the bottom of the rep.
- Hamstrings and calves help a little.
- Where you put your feet shifts the work: a lower foot position worked the quads more, and a higher one worked the glutes more [2].
Setup
- Set the back pad so you can bend your knees fully without your hips lifting.
- Sit with your back and hips flat against the pad.
- Place your feet in the middle of the platform, about hip- to shoulder-width apart, toes turned slightly out.
- Press the sled up and release the safety handles.
How to do it
- Lower the sled by bending your knees towards your chest.
- Keep your knees in line with your toes.
- Go as deep as you can while your hips and lower back stay flat on the pad.
- Press the sled away through your whole foot.
- Stop just short of locking your knees at the top.
from legs nearly straight to as deep as you can go with your hips flat on the seat.
about 2 seconds down, a steady press up.
Common mistakes
Hips rolling up at the bottom
Your lower back rounds off the pad under load
Stop the rep before your hips lift, or move the back pad.
Locking the knees hard
The weight rests on the joint instead of the muscles
Stop just short of straight.
Tiny reps with a huge load
The quads worked less with less knee bend [1]
Lower the weight and use the full range you control.
Pushing through the toes
Your heels lift and your knees take more strain
Press through your whole foot.
Make it easier or harder
One leg at a time doubles the load each leg handles for the same weight on the sled.
Variations and alternatives
Glutes [2]
You want more glute work from the same machine.
Quads [2]
You want to bias the quads.
Quads, glutes and core, with a free bar
You want a free-weight lift that also trains your trunk.
Quads only, including the rectus femoris
You want to finish the quads after a compound lift.
Where to fit it into your workout
First or second on leg day. It's a compound lift, so it comes before leg extensions and curls.
Sets and reps: 3–4 sets of 8–15 reps. Heavy and light loads built similar muscle when the sets ended close to failure [3].
Rest: 2 minutes.
How often: train your legs at least twice a week [4].
What to pair it with: a leg curl or hip hinge for the hamstrings, and a calf raise.
Safety
- Use the safety stops and release them only once the sled is pressed up.
- Keep your hips on the seat. Don't go deeper than you can without your lower back rounding off the pad.
- Check with a doctor or physical therapist first if you have an injury, pain or a medical condition, or are pregnant.
- Stop the set if you feel sharp pain, joint pain, dizziness or chest pain. Muscle burn and effort are normal; pain is not.
- This page is general information about exercise technique. It isn't medical advice and doesn't replace advice from a professional who knows your health. See our Terms of Service.
Questions people ask
Where should I put my feet on the leg press for glutes?
Higher on the platform. A high foot position worked the glutes more than a low one [2].
Where should I put my feet on the leg press for quads?
Lower on the platform, as long as your heels stay down. A low foot position worked the quads more [2].
How many reps should I do on the leg press?
8–15 per set suits most people. What matters most is finishing each set close to failure [3].
Is the leg press good for beginners?
Yes. The machine sets the path and your back is supported, so you can learn to work your legs hard with little technique.
Sources
- 1Martín-Fuentes I, Oliva-Lozano JM, Muyor JM. Evaluation of the lower limb muscles' electromyographic activity during the leg press exercise and its variants: a systematic review. Int J Environ Res Public Health. 2020;17(13):4626.
- 2Da Silva EM, Brentano MA, Cadore EL, De Almeida APV, Kruel LFM. Analysis of muscle activation during different leg press exercises at submaximum effort levels. J Strength Cond Res. 2008;22(4):1059–65.
- 3Schoenfeld BJ, Grgic J, Ogborn D, Krieger JW. Strength and hypertrophy adaptations between low- vs. high-load resistance training: a systematic review and meta-analysis. J Strength Cond Res. 2017;31(12):3508–23.
- 4Schoenfeld BJ, Ogborn D, Krieger JW. Effects of resistance training frequency on measures of muscle hypertrophy. Sports Med. 2016;46(11):1689–97.



